Saturday, November 29, 2008

Mission Style Wall Bed


This is a mission style Murphy wall bed that was completed on October 18th. The customer requested only one bookcase to accompany bed. It is one of my favorite Murphy beds but not to build. There are many parts that make up the face compared to some of the others that I build.

The wood is Red Oak with a Red Oak stain from Minwax. I then clear coat it with 2 coats of pre-catalyzed lacquer by Sherwin Williams.

The mission style crown I make myself and is set at a 45 degree angle. I start with 3 ½” wide board and cut the two back angles. I don’t take it down to a point. I leave a little material to ride against the fence on the subsequent cuts, since I have a right tilt table saw. After both back angles are cut, I flip the board over, adjust the fence and cut the face side slightly. This gives the crown another shadow line so that it looks like it is no just a flat board up there. Since they are cut at 45, they will be 90 degrees to the backs and therefore to the piece when it is mounted. I thought I’d share that with you. Hope you find it useful. I also used the same mission crown on the feet of Chandlers Table.

More pictures can be viewed in the October archives or the Current Projects link.

More pictures
mission murphy wall

As always you can see us live
goto http://www.ustream.tv/channel/wwbeds-shop